Heltun five-channel switch

The HELTUN touch panel is a multifunctional 5-channel Z-Wave switch that can be easily integrated into any standard round or square mounting boxes.

It has an elegant design, a thin flame-resistant housing, tempered glass and is available in 24 different color combinations: 6 glass colors and 4 types of frames that will suit any interior design.

White frame:

Black frame:

Chrome frame:

The frame is Silver:

The HELTUN touch panel is designed to control lighting (on/off and dimmers), curtains, blinds, gates, locks, valves, and other electronic devices. It has 5 relay outputs with max. with a load of 5A (1000-1200 Watts) each. Two independent inputs allow the relay to be used as dry contacts or to have two different voltages at the output. For example, you can simultaneously control 220V lighting and 12V motors.

All 6 buttons are fully touch-sensitive with good sensitivity and response to pressing.

The device is also equipped with temperature, humidity and light sensors. And if you set the power parameters of the connected loads, then a special algorithm will calculate the total power consumption.

Up to 90 different associations can be configured on the device and additional relays or other devices can be connected. There are special association modes that allow you to control the dimmers and motors.

HELTUN Touchpad It has 5 relays, 5 touch buttons and a two-color (red and blue) backlight for each button. The device has flexible settings such as: button behavior, network diode behavior, and relay behavior when pressing/holding a button or receiving broadcast commands, on/off time, and more.:

1. Each relay can be controlled by any touch button, via a Z-Wave controller or an associated device

2. Each touch button can be configured to control any relay (from one to five) in the following modes:

• When pressed, the relay output switches only to the ON state (contacts are closed)
• when pressed, the relay output switches only to the OFF state (contacts are open)
• when pressed, the relay output changes (inverts) condition
• When pressed, the relay output will be on for a certain amount of time, then off. The time can be set from 1 to 240 seconds. This function can be used to open/close garage doors, curtains, etc.
• When pressed, the relay output will be disabled for a preset time, then it will turn on. The time can be set from 1 to 240 seconds. This function can be used to turn off some devices for a short time (for example, an alarm or a lock).
• When the button is held down, the relay output is turned on (closed), as soon as the button is released, the output turns off (opens).
• When the button is held down, the relay output is disabled, as soon as the button is released, the relay switches to the on state (contacts are closed).

Each touch button can also be used to trigger scenarios or modes in the controller or associated device.

3. Each button light can be adjusted to

• show relay status
• show the status of the touch button
• show the status of a mode in the controller or associated device

moreover, you can choose the backlight color for each state yourself.

Touch panel HELTUN It is supported in all major controllers in Russia - Fibaro, Z-Way, Vera, Zipato, HomeSeer.

The device has a fifth-generation chip, and it is one of the first devices to implement S2-type security (AES 256 encryption for data transmission), both with and without an authorization key.

HELTUN provides an extended 2-year warranty for all its devices.