Smartec ST-NC120F Network Controller

(0)

$176

pcs.

Comparison

The Smartec ST-NC120F network controller is designed for one two-way access point, two Wiegand 26 and Wiegand 34 card readers and two ST-FR015EM fingerprint scanners connected via RS-485. Compatible with most codebase panels. Supports identification by card, fingerprint, code, or a combination of both.

Specifications:

The number of users is 30,000.
The number of fingerprints is 3000.
The number of events is 100,000.
The number of time zones is 256.
The number of access levels is 256.

The controller is based on a 32-bit 400 MHz processor, the OS is Embedded Linux. Timex software is pre-installed.

Functionality:

Lock control of the normally open or normally closed type.
Unblocking on the first card.
Support for the anti—passback ban.
Pass code support under duress.
Access via multiple cards (the N-person rule).
Gateway mode (when the door sensor is connected).
System freeze protection is a hardware watchdog timer.

It works for a long time and retains full functionality without constant communication with the server. Data storage is provided by 256 MB Flash memory and 32 MB RAM.

Hardware protection measures to enhance security:

Over-current, over-voltage protection.
Over-voltage protection across all communication ports.
Over-voltage protection across all inputs/outputs.
From the reverse polarity of the power supply.

DIP switches are installed in the ST-NC120F to turn on the terminator and set the device address in the RS-485 bus. It is equipped with indicators for card reading, data transmission over the RS-485 bus when communicating with readers and PCs, connection status and data transmission over TCP/IP.

Interfaces:

Network port.
RS-485 for communication with a PC.
RS-485 for communication with peripherals.
Inputs for connecting the power supply to the controller and the lock.
The lock relay.
Reed switch connection input.
The input is connected to the exit button.
An additional input for connecting security sensors and detectors (smoke, gas leak, movement, etc.).
Additional output for connecting external equipment, sirens, etc.

It is supplied without a case. The operating temperature range is 0 ° C... +55 ° C. Power supply — DC 12 V. Current consumption is up to 350 mA (excluding readers). The size of the controller is 186×106×36 mm.