Relay for controlling the electromechanical POPP lock

Appointment

 The device is ideally suited for controlling electromechanical locks. The relay controls dry contacts, but it can also switch loads up to 24 V / 2 A.

The device can be in two states - normally open and normally closed - these states are set using parameters. Do not leave the lock open without these parameters - very strong heating occurs.

The relay can be powered in three different ways:

• converter 8-12 V AC 
• converter 8-24 V DC
• battery 9 V 

 The device comes with a lock that can be controlled using a relay, and an adapter for battery power.

 The relay is fully compatible with most controllers and devices, so there are no limits to its use. For example, you can configure the lock to be opened with an RFID card. 

 Technical specifications 

• Radio protocol: Z-Wave
• Operating frequency: 869 MHz (officially allowed frequency in the Russian Federation)
• Power supply: 9-24 V DC
• Max. operating temperature: +300°C
• Degree of protection: IP20
• Latch size: 3 mm
• Latch dimensions: 61.8mm x 16.5mm x 25.5mm
• Max load: 24 V / 2 A