Line-interactive uninterruptible power supply Ippon Smart Winner 2000E

The line-interactive Smart Winner 2000E UPS is designed for simultaneous connection of up to eight devices via IEC 320 C13 connectors. Provides a clean sine wave at the output. Cross-factor (nonlinear load power supply with pulsed power consumption) — ≥ 3:1. The full power of the UPS is 2000 VA, the active power (maximum load) is 1800 watts.

Autonomy

The backup power sources are four 9 Ah lead-acid batteries. The usual switching time is 2 ms, the maximum is 10 ms. Duration of offline operation:

• PC with 17" monitor — 103 min.
• 30 % load — 20.1 min.
• 50 % load — 10.7 min.
• 70 % load — 5.9 min.
• 100 % load — 3 min..

Restoring the battery charge after full discharge to 90% in 4 hours. An increase in battery life is available due to external additional battery modules.

Protection modes and functions

Operating modes:

• The normal range is the mains supply of devices at a voltage of ± 20% of the nominal value and a frequency of 50/60 Hz ± 5 Hz.
• Extended range — mains supply of devices at a voltage of -30% ~ +20% of the nominal value.
• Powered by batteries.
• The generator mode is to power the devices from the mains at a frequency of 40 ~ 70 Hz, outside this range — battery power.
• Standby mode — no power is supplied to consumers, the batteries are being charged.

In the normal range mode (161...276 V), the AVR regulator lowers the output voltage by 12% (0.88×Uvc) at Uvc > 233 V and increases by 14% (1.14×Uvc) at Uvc < 198 V.

Protection functions:

• From high-voltage emissions (405 J), short circuit, overheating.
• Overload protection > 110% with mains and battery power.
• Pulse interference protection: protection of lines connected via RJ-11/RJ-45 connectors.
• At a load of less than 5%, the source is after 5 minutes. it will turn off automatically (you can turn off this function if necessary).

It is acceptable to use the UPS in cold start mode — on batteries, without connecting to the mains.

Management

Buttons and an information LCD display with a graphical LCD are provided for controlling and configuring the UPS, demonstrating the current operating mode and values: load power, battery charge level, voltage, current frequency, etc. For switching with a PC or server, the UPS is equipped with RS-232 and USB type B ports. The source is equipped with "dry contacts".

Management functions:

• Support for the SNMP protocol and a universal slot for SNM cards allow you to control the source over the Internet and exchange data with various types of devices.
• EPO — emergency shutdown of the power supply to consumers; remotely activated in emergency situations.

Basic parameters

The UPS package includes cables: 2×IEC power supply, USB, RS-232, telephone. The design is universal: mounting horizontally, vertically or in a rack (rack mounts are not included). Fan cooling, noise < 50 dB, IP20, dimensions 438×86.5×436 mm, net weight — 21 kg.