Powercom Smart King Pro+ SPR-2000 LCD UPS

The line-interactive Powercom Smart King Pro+ SPR-2000 LCD UPS for nine consumers connected via eight IEC320 C13 and one IEC320 C19 connectors provides a pure sine wave output voltage, which allows you to connect equipment with both pulse and transformer power supplies. The total power is 2000 VA. The active power is 1600 watts.

Filtering and protection

UPS supplies mains voltage in the 155 V ~ 300 V range to consumers and automatically adjusts it at the output (AVR) according to the principle of a step-by-step autotransformer. The adjustment limits depend on the rated voltage: for 220 V, when the input voltage is lowered, it increases the output voltage by 9% ~ 27.5%, and when it is increased, it lowers by 9% ~ 30%; for 230 and 240 V, it lowers and increases by 9% ~ 25%. When the mains voltage is de-energized or exceeds the regulated range, the UPS switches to backup power.

Other functions:

• Surge protection — 420 Joules dissipation in 8/20 microseconds.
• Automatic shutdown as overload protection: at 110% load — after 20 seconds, at 125% — after 5 seconds.
• Short circuit protection — instant disconnection from consumers.
• Protection of RJ-45 ports from radio frequency and electromagnetic interference in the network — built-in EMI/RFI filter at the input of the source, 100 kHz ~ 10 MHz.
• Green Mode — turns off the UPS when there is no or low (up to 30 W) load; non-switchable function.
• Cold start — turning on the UPS and supplying voltage to consumers in the absence of mains power only by charging the battery.
• Hot battery replacement.
• Automatic battery charging when the UPS is turned off.
• Protection against deep battery discharge, battery replacement indicator.
• Automatic self-testing of UPS and batteries.

Autonomy

Backup power is provided by two sealed 12 V 9 Ah lead-acid batteries. The duration of switching to battery support mode is 2~4 ms. Output voltage in offline mode: when the battery is sufficiently charged — ± 5% of the nominal value (220, 230 or 240 V), after a low charge signal -10%. The duration of battery charge recovery to 90% is 3 hours.

Basic parameters

The SPR-2000 LCD is equipped with USB ports with support for the Smart Battery standard and RS-232 with a dry-contact interface for communication with computer software (monitoring, schedule of power-on and off, PC shutdown) and a slot for an SNMP adapter (not included) for 10/100-BaseT networks. An LCD display and LED indicators are provided to control the UPS operation parameters, and an audible alarm is provided for alarm alerts (low battery charge, overload, switching to battery support mode).

The installation of the model is rack—mounted (in a 19" rack) or floor-mounted (stand and "ears" included). The operating temperature range is 0 ° C... +40 ° C. Noise level —

Standard equipment:

• Powercom Smart King Pro+ SPR-2000 LCD UPS.
• The input power cord is 1.2 meters (removable).
• The output power cord.
• A set for installation in a 19" rack and on the floor ("lugs" for a rack and a stand for floor installation).
• Connecting telephone cable.
• USB communication cable.
• The software disk.
• User manual.
• The warranty card.